Some of the original moisture has already condensed during compression, and separated in the compressor. Our unique brazed plate heat exchanger (BPHE) solutions include our ADWIS units and dual-over-two-pass (D2P) configurations. End-user applications include water-to-water cooling, compressor cooling, heat recovery and condensers.
The basic flow principle in a brazed plate heat exchanger for refrigeration applica-tions is parallel or diagonal flow to achieve the most efficient heat transfer process.In a single pass design, all connections are located on one side of the heat ex-changer, making installation very easy.Multipass design and different types of connections are available. Optionally, the location of connections can be chosen. Brazed Plate Heat Exchangers General Air-ConditioningBPHE B3-030 brazed plate heat exchanger is the ideal choice for chillers, heat pumps, economizers, de-superheaters and can be used for numerous other applications. The heat exchanger is designed to combine high thermal efficiency with energy savings. Refrigerants :R407C, R22, R404A, R410A, R134A. Design temperature :196 to +200ºC/320 to +392ºF.
3-in-1 heat exchanger - include evaporator, Separator, pre-cooler/heater Air compressor compresses hot and moist air to the pre-cooler of a 3-in- 1 heat exchanger, then the hot & moist air exchanges heat with treated cold air. This chilled moist air enters the evaporator, lower down temperature and condensate water out by evaporation. Air compressors - SWEP Brazed plate heat exchangersThe air reaches approximately 100 °C in an oil-lubricated compressor, and 200 °C in an oil-free compressor. The large difference in volume flows between the air and coolant sides means that this application has traditionally been dominated by the naturally asymmetric Shell & Tube technology. Today, however, compact installations using SWEP brazed plate heat exchangers (BPHEs) are available.
Your email address will not be published.*